Loading cards into the printer (continued), Loading cards into the printer – FARGO electronic S000256 User Manual
Page 144
RESTRICTED USE ONLY
FARGO Electronics, Inc.
Loading Cards into the Printer
The printer will hold a maximum of 100 cards in its Card Hopper (based on a standard CR-80
card size). The Printer automatically feeds each card and adjusts to each cardís particular
size and thickness. Significantly larger or thicker cards, however, may require slight printer
adjustments for consistent printing. To load the cards into the printer, refer to the following
steps:
Step Procedure
1
Remove a stack of 100 or fewer cards from the card packaging. Do not touch the
area of the card where you intend to print. Oil or dirt from your hands can impair
print quality.
2
Open the Card Hopper Door located on the right-hand side of the printer ís exterior
by grasping the top of the door and pulling down. Allow the door to swing
completely open.
Persona
® C25 Card Printer User Guide (Rev. 4.0)
144