FARGO electronic S000256 - Manual (Page 140)

RESTRICTED USE ONLY FARGO Electronics, Inc.
Section 5: Printer Setup
Choosing a good location
Place the unit in a location with adequate air circulation to prevent internal heat build up.
Step Procedure
1 Use the dimensions specified in Section 9 as a guideline for the minimum
clearances to the unit. NOTE: Allow for adequate clearance above the unit to
accommodate the height of the unit with its cover open.
2 Do not install unit (a) near heat sources such as radiators or air ducts, or (b) in a
place subject to direct sun-light, excessive dust, mechanical vibration or shock.
About Moisture Condensation
If the unit is brought directly from a cold to a warm location, or is placed in a very damp room,
moisture may condense inside the unit. Should this occur, print quality may not be optimum.
Leave the unit turned OFF in a warm, dry room for several hours before using. This will allow
the moisture to evaporate.
Unpacking and Packing the Printer
Unpacking the Persona C25 Card Printer
The purpose of this section to provide the User with a specific unpacking procedure for the
Persona C25 Card Printer.
Step Procedure
1 While unpacking your printer, inspect the carton to ensure that no damage has
occurred during shipping.
Make sure that all supplied accessories are included with your unit. The following
items should be included with your printer: Printer, Power Supply, Cleaning
Roller Assembly (pre-installed), Software Installation CD, Warranty Statement,
and Registration Card.
2 Save the carton and packing materials.
Persona
® C25 Card Printer User Guide (Rev. 4.0)
140