Section 4: cleaning, Safety messages (review carefully) – FARGO electronic S000256 User Manual

Page 130

Advertising
background image

RESTRICTED USE ONLY

FARGO Electronics, Inc.

Section 4: Cleaning

This section deals with the Printer’s internal and external maintenance in regards to the unit's
cleaning and general upkeep. The Printer should be cleaned on a regular basis to insure
that the Printer consistently produces high quality output.

Danger: Be sure to disconnect the Printer's power cord whenever performing any

type of maintenance procedure unless otherwise directed.

Safety Messages (review carefully)

Symbol

Critical Instructions for Safety purposes

Danger:

Failure to follow these installation guidelines can result in death or
serious injury.

Information that raises potential safety issues is indicated by a warning
symbol (as shown to the below).

• To prevent personal injury, refer to the following safety messages

before performing an operation preceded by this symbol.

• To prevent personal injury, always remove the power cord prior to

performing repair procedures, unless otherwise specified.

• To prevent personal injury, make sure only qualified personnel

perform these procedures.

Caution:

This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.

Information that raises potential electrostatic safety issues is indicated
by a warning symbol (as shown to the below).

• To prevent equipment or media damage, refer to the following

safety messages before performing an operation preceded by this
symbol.

• To prevent equipment or media damage, observe all established

Electrostatic Discharge (ESD) procedures while handling cables in
or near the Circuit Board and Printhead Assemblies.

• To prevent equipment or media damage, always wear an

appropriate personal grounding device (e.g., a high quality wrist
strap grounded to avoid potential damage).

• To prevent equipment or media damage, always remove the

Ribbon and Cards from the Printer before making any repairs,
unless otherwise specified.

• To prevent equipment or media damage, take jewelry off of

fingers and hands, as well as thoroughly clean hands to remove oil
and debris before working on the Printer.

Persona

® C25 Card Printer User Guide (Rev. 4.0)

130

Advertising