Furuno FR-2115-B - Manual (Page 18)

1-10
1.3.2 Mounting the monitor
1. Drill four holes of 12 mm in diameter in the mounting location, referring to the outline
drawing for mounting dimensions.
2. Unfasten two M4X10 screws to dismount the monitor cover.
3. Unfasten two sets of M10 bolts, plain washers and spring washers at the front of the monitor
to separate the monitor from the mounting base.
4. Pull the monitor forward about 4 centimeters and then lift if from the mounting base.
5. Fasten the mounting base to the mounting location with M10 bolts, nuts and washers (local
supply), using the pipe box wrench supplied. Make sure there is 3mm protrusion under the
nut.
6. Lay the monitor on the top of the mounting base, making sure the rear pin on the monitor is
mated with the slit in the mounting base. Fix the mounting base with the two sets of bolts,
and washers unfastened at step 3.
7. Fasten the monitor cover.
Monitor Cover
Pan-Head Screw
M4X10, 2 pcs.
Hex Bolt
M10X30,
2 pcs.
Spring Washer, M10, 2 pcs.
Plain Washer, M10, 2 pcs.
Mounting Base
Hex Bolt
M10, 4 pcs.
Washer
Pin
Slit
Hex Bolt.
(M10)
Mounting Base
More than 3mm
Figure 1-7 Monitor