Furuno FR-2115-B - Manual (Page 52)

4-13
4.4 Performance Monitor PM-30
Necessary parts: PM-30 and OP03-150 (Code no. 008-485-490)
Name Type Code No. Qty
PM-IN Board 03P9225 008-487-620 1
Pan-head Screw B M3X8 C2700W 000-881-404 3
Connector Assy. VH3P-L300-AA 000-141-014 2
1. Open the processor unit. Unfasten three screws to remove the RGB Board together with its
mounting plate. Unfasten the monitor cable at the RGB Board. (See Figure 4-9 on page 4-10
for location.)
2. Fasten the PM Board 03P9225 to the location shown below with three M3X8 pan-head
screws.
J401
J411
PM Board
03P9225
J402
J403
Figure 4-13 Processor unit, inside view
3. Connect J411 to J401 on the PM Board.
4. Connect two connector assemblies (VH3P-L300-AA) to J402 and J403.
5. Solder the other end of the connector assemblies with external cables, one from ship's
mains and one from the PM-30.
6. Fasten the RBG board and its mounting plate and connect the monitor cable. Close the
processor unit.