Furuno FR-2115-B - Manual (Page 23)

2-4
2.1.2 Fabricating signal cable S03-75
1. Remove the vinyl sheath by 450 mm.
2. Slide the clamping ring, washer, rubber gasket
and washer onto the signal cable in that order.
3. Unravel the outer shield to expose the cores in
the outer layer. Then, unravel the inner shield to
expose the cores in the inner layer. Label all
inner cores to aid in identification.
4. Attach EMI cores to all inner cores and all outer
cores, and bind them with cable ties, etc. Note
that there are two types of the EMI cores, thick
and thin.
5. Trim each core (except coaxial wire) considering
its location on the terminal board in the antenna
unit.
6. Trim the inner and outer shields leaving 500 mm
each. Twist shields together and attach crimp-on
lug FV5.5-4 (blue,
φ
4).
7. Remove insulation of each core by about 6 mm.
Fix crimp-on lug FV1.25-3 (red,
φ
3) to each core.
8. Fabricate the coaxial cable. Make the length 10
mm longer than the shield to prevent wire strain.
Attach crimp-on lug FVD1.25-3 (red,
φ
3) to
coaxial cable.
Clamping
ring
Washers
Rubber
gasket
Crimp-on lug
FV5.5-5
(Blue,
φ
4)
Figure 2-7 How to ground
signal cable S03-75
Figure 2-6 How to fabricate
signal cable S03-75
VINYL SHEATH
Inner shield
6 mm
Crimp-on lug
FV1.25-M3
(Red,
φ
3)
450 mm
45 mm
Crimp-on lug
FVD1.25-3
(Red,
φ
3)
2C-2V
Cut here
50 mm
6 mm
Fold four times
Crimp-on lug
FV1.25-3
(Red,
φ
3)
75 mm
500mm
Coax cable
Outer cores
Inner cores
= EMI cores
Outer cores: RFC-13 (thick)
Inner cores: RFC-10 (thin)
Cable tie
Under
100 mm
70-130 mm