Frymaster FOOTPRINT PRO SERIES 35 - Manual (Page 34)

4-9
4.4 Disassembly and Reassembly of the Magnasol Filter
Dissassembly
1. Grasp the frame with your thumbs on the handles at the corner of the assembly and pull outward
in opposite directions to separate the frame at the corner. Continue to open the frame (it will
pivot at the opposite corner) until the outer screens and grid can be removed from the frame.
Step 1 - Grasp frame with
thumbs on these handles and
pull frame appart at corner.
Step 2 - Separate
the outer screens
and grid.
2. Separate the outer screens and grid.
Cleaning
1. Daily – Clean the outer screens, grid, and frame using a good quality degreaser and hot water
from a spray nozzle. The groove in the seal frame pieces can be cleaned with the edge of a
Scotch-Brite™ or similar cleaning pad.
Allow all filter assembly components to air dry or thoroughly dry with clean towels before
reassembling.
2. Additionally, at each scheduled boil-out, disassemble the leaf filter assembly and place in the
frypot being boiled out. Follow the boil-out procedure in Section 5.1.2 of this manual.
Reassembly
1. Place the two outer screens together and align their edges (see illustration on following page).
2. Insert the screens into one of the frame halves (it doesn’t matter which one). Ensure that the
fitting in the bottom screen is on the opposite side of the frame from the handle.
3. Slip the grid between the screens, ensuring that the grid is centered between the edges of the
screens.
4. Connect the other half of the frame at the corner opposite the handles and pivot the frame onto
the free edges of the screen.