FUJITSU FIJITSU Image Scanner fi-5750C - Manual (Page 33)

CONTENTS
Introduction
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATION
2.1 Turning the scanner ON/OFF
2.2 Setting the ADF
2.3 Loading documents onto the ADF
2.4 Scanning document using the Flatbed
2.5 Scanning documents
2.6 How to use the Scanner Driver
3 SCANNING VARIOUS TYPES OF DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 ONLINE SETUP
8 DOCUMENT SPECIFICATION OF ADF
9 OPTIONS
10 SCANNER SPECIFICATIONS
Appendix
2.3 Loading documents onto the ADF (Continued from the previous page)
5. Adjust the stacker extension according to the document size and raise the stopper.
6. Adjust the position of the stacker.
The mount position of the stacker can be changed. The stacker is normally mounted on the Lower position. If you scan thin papers or
curl papers, you will remount the stacker to the upper position.
Lower position Upper position
ATTENTION
When the stacker is mounted on the upper position, the stacking capacity decreases (Around 100 sheets at 80g/m2).
1 | 2 | 3 | 4 | 5 | 6
All Rights Reserved, Copyright (C) PFU LIMITED 2003