FUJITSU FIJITSU Image Scanner fi-5750C - Manual (Page 65)

•
CONTENTS
Introduction
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATION
2.1 Turning the scanner ON/OFF
2.2 Setting the ADF
2.3 Loading documents onto the ADF
2.4 Scanning document using the Flatbed
2.5 Scanning documents
2.6 How to use the Scanner Driver
3 SCANNING VARIOUS TYPES OF DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 ONLINE SETUP
8 DOCUMENT SPECIFICATION OF ADF
9 OPTIONS
10 SCANNER SPECIFICATIONS
Appendix
2.6 How to use the Scanner Driver (Continued from the previous page)
[Setup IPC...] button
This button displays the Image Processing dialog. This button is enabled when Image Processing Software Option (separately sold) is
installed and "Image Processing" is selected in the "Image Mode". Refer to the documentation provided with Image Processing Software
Option.
End of Page Detection
Scans the edge (bottom) of the documents and outputs data adjusted to the document length. When any page shorter than specified "Paper
Size" is included, the output size is adjusted to the detected short size.
1 ··· 10 | 11 ··· 20 | 21 | 22 | 23 | 24 | 25 | 26 | 27 | 28 | 29
All Rights Reserved, Copyright (C) PFU LIMITED 2003