Furuno GP-80 - Manual (Page 20)

5. INITIAL SETTINGS
17
14) Output data from the computer. When data is loaded, the cursor shifts to Stop.
15) Press the [ESC] key.
Setting DATA 4 to DGPS
An external DGPS receiver can be connected to the DATA 4 port.
Follow the procedure below to setup the GP-80 according to the specifications of the DGPS
receiver.
1) Press [MENU] [9] and [5].
2) Press
! or " to select Level.
3) Press # or $ to select level; RS232C or RS422.
4) Press the [ENT] key.
5) Press
# or $ to select DGPS.
6) Press " to select To Next Page.
DATA 4 I/O SETUP "DGPS" 2/2
To previous Page
First Bit
Parity
Stop Bit
Baud Rate
: Select
ENT: Enter MENU: Escape
MSB LSB
EVEN ODD NONE
1 2
4800 9600
Figure 5-8 DATA 4 I/O SETUP "DGPS" 2/2 menu
7) Press
! or " to select First Bit.
8) Press # or $ select first bit; MSB or LSB.
9) Press " to select Parity Bit.
10) Press # or $ to select parity bit; EVEN, ODD or NONE.
11) Press " to select Stop Bit.
12) Press # or $ to select stop bit; 1 or 2.
13) Press " to select Baud Rate.
14) Press # or $ to select baud rate; 4800 or 9600.
15) Press the [ENT] key.
16) Press the [ESC] key.