Furuno FAR-2827 - Manual (Page 29)

2. WIRING
2-5
11. Set the transceiver module to the antenna unit, push it in until it stops, and then tighten
fixing bolts (4 pcs.). Connect plugs P823, P803, P831, P921 and J911 (if installed).
Fasten the shield wire to the wing nut on the transceiver module.
CAUTION
Push in transceiver unit until it stops.
Failure to do so may cause leakage of
microwaves.
03P9349
Bow mark
Connector
plug
Clamp for
coaxial cable
Connect coaxial cable here.
Signal cable
Cable clamp for
antenna cable
Transceiver module
Connect shield wire to with wing
nut at the opposite side of the
transceiver module.
Antenna unit, front view
12. Confirm that all screws are tightened and all wiring is properly made. Confirm that
waterproofing gasket, bolts and tapping holes of antenna unit are coated with silicone
grease. Close the antenna unit cover (torque: 2.5 N·m).