Festool 1010 EQ - Manual (Page 10)

10
4.2 Switching the machine on and off
Keep the machine steady during switching and
during use by holding the handle (5.1) and the additional
handle (5.4) with both hands.
The switch (5.3) is used to switch the tool on and off. For
continuous operation the switch can be locked by means of
the button on the side (5.2). The switch can be unlocked by
pressing again.
After the machine has been switched off, the
milling cutter will still rotate for a time. Take care that parts
of your body do not come into contact with the milling cutter
while it is still rotating!
3.4 Clamping collet changing
- Fully unscrew the collet nut (3.2) and remove from spindle
together with the clamping collet.
- Insert a new clamping collet with nut into the spindle and
slightly tighten the collet nut.
Do not tighten the collet nut until a milling cutter has been
fitted!
Milling cutter removel
- Turn the spindle until the spindle stop (3.1) catches when
pressed and the spindle is locked in place.
- Loosen the collet nut (3.2) using a 19 mm open-ended
spanner until a resistance is felt. Overcome this resistance
by turning the open-ended spanner even further.
- Remove the cutter.
4 Operation
4.1 Adjusting the milling depth
Before adjusting the milling depth always
disconnect the mains plug from the socket!
The milling depth is adjusted in three stages:
a) Setting the zero point
- Open the clamping lever (4.4) so that the stop cylinder (4.5)
can be moved freely.
- Place the router with router table (4.7) onto a smooth surface.
Open the rotary knob (4.8) and press the machine down
until the milling cutter rests on the base. Clamp the machine
tight in this position with the rotary knob (4.5).
- Press the stop cylinder against one of the three sensing stops
of the pivoted turret stop (4.6).
The individual height of each sensing stop can be adjusted
with a screwdriver:
Sensing stop min. height max. height
A 38 mm 44 mm
B 44 mm 54 mm
C 54 mm 67 mm
- Push the pointer (4.1) down so that it shows 0 mm on the
scale (4.3).
b) Setting the milling depth
The desired milling depth can be set either with the quick
depth adjustment or with the fine depth adjustment.
Quick depth adjustment:
Pull the stop cylinder (4.5) up until the pointer shows the
desired milling depth. Clamp the stop cylinder in this position
with the clamping lever (4.4).
Fine depth adjustment:
Lock the stop cylinder with the clamping lever (4.4). Set the
desired milling depth by turning the adjusting wheel (4.2) in.
Turn the adjusting wheel to the next mark on the scale to
adjust the milling depth by 0.1 mm. One full turn adjusts the
milling depth by 1 mm. The maximum adjustment range with
the adjusting wheel is 8 mm.
c)
Increasing the milling depth
Open the rotary knob (4.8) and press the tool down until the
stop cylinder touches the sensing stops.