Festool 1010 EQ - Manual (Page 14)

14
Copying device
The angle arm WA-OF (10.3) and copier scanning set KT-OF,
consisting of roller holder (10.2) and three copying rollers
(10.1), are required for the copying device.
- Screw the angle arm at the desired height in the platen’s
threaded bore (10.7) with the rotating knob (10.6).
- Fit a copying roller in the roller holder and bolt this to the
angle arm with the rotating knob (10.4). Make sure that the
copying roller and cutter have the same diameter!
- Turn the adjusting wheel (10.5) to adjust the distance
between the copying roller and cutter axis.
5 Servicing and maintenance
Any maintenance or repair work that requires
opening of the motor or gear housing should only be carried
out by an authorised Customer Service Centre (name supplied
by your dealer) ! Maintenance or repair work carried out by
an unauthorised person can lead to the wrong connection of
the power leads or other components, which in turn can lead
to accidents with serious consequences.
g) Edge band trimming
Protruding edge bands can be flush trimmed with the angle
arm WA-OF (11.4) in connection with the guide plate UP-OF
(11.5).
- Screw the angle arm into the platen’s threaded bore (11.1)
with the rotating knob (11.2).
- Bolt the guide plate to the angle arm with the rotating knob
(11.3).
- Adjust the milling depth so that this is equal to the thickness
of the edge band + 2 mm.
- Move the guide plate (11.5) as close as possible to the cutter
by loosening the rotating knob (11.10).
- Adjust the depth of the guide plate with the adjusting wheel
(11.9) so that during trimming a few decimillimetres of the
edge band are left protruding which can then be sanded down
by hand.
The chip guard SF-OF (11.6), available as an accessory,
improves dust extraction when trimming edge bands. It is
fastened to the side of the platen with the rotating knob (11.7)
and cover the cutter from above during work.
4.4 Support of the workpieces
Ensure that your workpieces are securely fixed
and cannot move during routing. Otherwise, there is an
increased risk of accident. Use screw clamps or some other
suitable devices to fix your workpiece.
f) Copy cutting
A copying ring or the copying device is used to exactly
reproduce existing workpieces (both available as accessories).
Copying ring
- Fasten the copying rings (9.2) to the platen instead of the
cover ring (9.1) from below.
When choosing the size of the copying ring (9.2) make sure
that the cutter used (9.3) fits through the ring’s opening.
The distance Y between the workpiece and template is
calculated by:
Y = (Ø copying ring - Ø cutter) / 2
The copying ring can be centred exactly with the centring
cone ZF-OF (Order No. 486 035)