GE GFK-1852 - Manual (Page 10)

GFK-1852 Chapter 1 Introduction and Quick Start 1-3
Introduction and Quick Start
1
Quick Start
The easiest way to configure the IC200SET001 VMSE is over Ethernet. The
following steps need to be done, in the order listed, to configure the VMSE.
Preliminary Step
Connect the VSME to the Ethernet network.
Default IP Address
The VMSE is shipped with a default IP address of 0.0.0.0, which automatically
enables the DHCP within the VMSE.
NOTE: Using the ARP (Address Resolution Protocol) command (see below) you
can always override the IP address given to the VMSE by your DHCP server.
Procedure: Assigning a New IP Address
Use the following steps to assign an IP address over the network. All of the
following are done from the MS-DOS
 prompt of your personal computer. The
actual numbers and letters you must type are shown in bold type. This data is not
case-sensitive. You can access the MS-DOS prompt from your computer’s
Start/Programs submenu. For ease of reading on the printed page, many of the
screen images shown in the figures in this manual have been converted from their
normal white letters on a black background to black letters on a white background.
In the example shown in this section, the IP Address 3.16.27.44 will be assigned to
the VMSE.
The MAC address of the VMSE is required for assigning an IP address. Use the
MAC address that is printed on the side of your VMSE, which is of the format 00-
20-xx-xx-xx-xx. For this example, the MAC address 00-20-4A-51-0E-5B will be
used.
A. Type ping (any valid IP address on your network) at the MS-DOS prompt,
and then press the Enter key. (This step is required to “establish” the ARP table
by creating an entry in the table.) The address pinged should reply as shown in
the example in the next figure. In this example, the command and valid IP
address was typed as follows:
ping 3.16.16.14