GE GFK-1852 - Manual (Page 39)

GFK-1852 Chapter 4 Configuration 4-17
Configuration
4
Modbus TCP/RTU Firmware Configuration Setup
The next figure shows the Main Configuration screen for Modbus Firmware:
Figure 4-7. Modbus Hardware Configuration Screen
When finished with this screen, you have three choices:
•
Press the “S” key to exit and save your changes.
•
Press the “Q” key to exit without saving your changes.
• Press the “D” key to return to the default settings.
Network/IP Settings
To change the Network/IP settings, press ‘1’. The following values can be
set/changed: IP Address, Gateway Address, NetMask
IP Address
The IP address must be set to a unique value in your network. If you are not familiar
with IP addresses, please refer to Appendix A.
If the VMSE is given an address that is already in use it will not connect to the
network.