Generac 1403-0 - Manual (Page 7)

Generac Portable Products Power Transfer System
7
Connection Box
The installer should use local codes and the following
procedure to install the generator connection box
provided with this system.
16. Locate and mount the connection box on an
outside wall as close as possible to the load
center. However, consider household air intake
ducting when when locating generator and
connection box. A typical power transfer system
complete installation is depicted in Figure 11.
17. As shown in Figure 12, mount a junction box at the
appropriate distance from the Load Manager™
switches so that both 1/2” flexible conduits can be
connected to it.
Figure 12 — Junction Box Installation
Figure 11 — Typical Completed Power Transfer System Installation