Generac 1403-0 - Manual (Page 8)

Generac Portable Products Power Transfer System
8
18. Referring to Figure 13, remove the connection box
inner panel. Mount the connection box at its
planned location on an outside wall.
19. Run appropriately sized conduit from the junction
box to the connection box. Anchor all boxes,
conduit, and fittings.
20. Pull four properly-sized insulated wires through the
conduit joining the junction box and the connection
box. Trim and strip each wire in the junction box.
Make secure connections using wire nuts.
Figure 14 shows wires from one of the two Load
Manager™ switches installed. When both switches
have been connected, install the junction box
cover.
Figure 13 — Connection Box Installation
Figure 14 — Junction Box Connections