GE EPM 3000P - Manual (Page 29)

Chapter 7 Global Meter Setup
MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS
VOLTS PRINT
PROG PHASE
NEXT
0.
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS
VOLTS PRINT
PROG PHASE
NEXT
02.
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN
I20
Step 1:
a. Enter Group Level of Programming Mode
(see Chapter 6).
b. Press MAX/MIN/LIMITS until 0. appears in upper
display.
c. Press VOLTS to activate the Group.
Ö 02. appears in upper display.
Ö Lower display indicates current Baud Rate.
MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS VOLTS PRINT
PROG PHASE
NEXT
02
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN
24 _
MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS
VOLTS PRINT
PROG PHASE
NEXT
02.
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN
240
Step 2:
a. Press VOLTS to begin Data Entry Sequence.
b. Three dashes appear in lower display.
c. Press VOLTS to select.
Ö Repeat this procedure until new Communication Baud
Rate is entered.
Ö When complete, lower display indicates new Baud
Rate.
See Chapter 12 to Exit.
7.4 G ROUP 0, F UNCTION 3 - S YSTEM C ONFIGURATION
The System Configuration Function is used to set basic meter operational parameters. (This Function
utilizes Switch PACKS).
FUNCTION 3 contains six Switch PACKS, 0 - 5. Each PACK contains three individual UP/DOWN (toggle)
switches.
• Toggling the segment UP and DOWN, toggles the switch ON and OFF respectively, or chooses
between two options.
• The meter displays one Switch PACK at a time.
GE Industrial Services
24