GE EPM 3000P - Manual (Page 33)

Chapter 7 Global Meter Setup
Ö To change the TIME DELAY FOR RELAY 1 OR RELAY 2, follow these steps:
PRESS MAX/MIN/LIMITS, AT ANY TIME, TO CANCEL BEFORE STORING THE LAST DIGIT OR SWITCH.
MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS
VOLTS PRINT
PROG PHASE
NEXT
0.
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS
VOLTS PRINT
PROG PHASE
NEXT
04.
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN
060
Step 1:
a. Enter Group Level of Programming Mode
(see Chapter 6).
b. Press MAX/MIN/LIMITS until 0. appears.
c. Press VOLTS to activate the Group.
Step 2:
To program Relay 1:
a. Press MAX/MIN/LIMITS until 04. appears in upper
display.
To program Relay 2:
a. Press MAX/MIN/LIMITS until 05. appears in upper
display.
Ö Lower display indicates current Time Delays.
MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS
VOLTS PRINT
PROG PHASE
NEXT
04
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN
_
I2
MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS
VOLTS PRINT
PROG PHASE
NEXT
04.
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN
I25
Step 3:
a. Press VOLTS and two dashes appear in lower
display.
b. Press MAX/MIN/LIMITS and three dashes appear in
lower display.
c. Press PRINT/PROG for desired number.
• Press PRINT/PROG once and the blank signifies a
zero.
• Press PRINT/PROG twice and 1 appears.
d. Press VOLTS to store.
Ö Repeat this procedure until desired value is entered.
Ö Lower display indicates the current Time Delay.
See Chapter 12 to Exit.
28
GE Industrial Systems