GN Netcom ELT 560 - Manual (Page 11)

S
e
tt
in
g up
the
Ph
on
e
S e t t i n g u p t h e P h o n e [ 1 0 ] w w w . u n i d e n . c o m
Connect the base and charge the handset
1) Connect the AC adapter to the DC IN 9V
jack.
Place the base close to the AC outlet to
avoid long extension cords.
2) Connect the AC adapter to a continuous
power supply (i.e., an outlet that is not
controlled by a switch).
3) Close the handset and place it in the
base with the smaller LCD screen facing
forward.
4) Make sure that the charge LED illuminates.
If the LED does not illuminate, check to see that the AC adapter is plugged in and the
handset makes good contact with the base charging contacts.
5) Charge your handset at least 10 hours before plugging into the phone line.
6) Once the handset battery pack is fully
charged, connect the telephone line cord
to the TEL LINE jack and to a telephone
outlet.
To move the phone to a different
telephone outlet, first unplug AC
adapter and remove the battery.
Connect the telephone cord first,
then replace the battery and
connect the AC adapter.
•Use only the supplied
AD-800 AC adapter.
Do not use any other
AC adapter.
•Do not place the power
cord where it creates a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
•Don't place the base in
direct sunlight or
subject it to high
temperatures. The
battery may not charge
properly.
If your telephone
outlet isn't modular,
contact your
telephone company.
note
UP742.book Page 10 Thursday, February 3, 2005 9:39 PM