GN Netcom ELT 560 - Manual (Page 8)

Se
tting up the
Phone
[ 7 ] S e t t i n g u p t h e P h o n e w w w . u n i d e n . c o m
Battery Backup Feature
The battery backup allows you to make and receive calls during a power failure. You can
use any handset or the base, just as you would normally.
Install the power backup battery in the base
1) Open the battery case cover by pressing the release button on
the bottom of the base as shown.
2) Plug the battery connector (red and black wires) into the jack
inside the battery compartment. (The connector notches fit into
the grooves of the jack only one way). Match the wire colors to
the polarity label in the battery compartment, connect the
battery and listen for a click to insure connection.
3) Make sure you have a good connection by gently pulling on the
battery wires. If the connection is secure, the battery jack will
remain in place.
4) Place the battery case cover back on the base.
5) Align the tabs on the cover with the grooves on the base, and
press down the cover until it clicks into place.
•To use the battery
backup feature, you
need to connect the AC
adapter to the base,
and charge the base
battery at least for 24
hours.
•During initial setup,
the AC Adapter must
be connected to
activate the base unit.
Once activated, you
can make or receive
calls using battery
backup.
•Use only the Uniden
(BT-446) rechargeable
battery pack supplied
with your cordless
telephone.
note
UP742.book Page 7 Thursday, February 3, 2005 9:39 PM