GN Netcom ELT 560 - Manual (Page 36)

Us
i
n
g Y
o
u
r
P
h
o
n
e
[ 3 5 ] U s i n g Y o u r P h o n e w w w . u n i d e n . c o m
Receiving a call/AutoTalk set to OFF
Hanging Up
Press end or close the top panel.
Switching to the Handset Speakerphone During a Call
To switch a normal call to the speakerphone, press (speaker phone) on the
handset. To switch from a speakerphone call to a normal call, press (speaker
phone).
Moving out of range
If you move your handset farther from the base unit during a call, you might start
to hear more noise than usual. If you go too far from the base, you'll hear a beep
and see
No Si gn a l P re s s H EL P on the display. The base will stay connected to the
caller for another 35 seconds, so you can move back within range to return to the
call.
Handset is in the cradle Handset is off the cradle
1) Remove the handset from the
charging cradle.
2) Flip the top panel up.
3) Press talk/flash.
1) Flip the top panel up.
2) Press talk/flash.
•If Open to Answer is
ON, the phone will
automatically answer
the call when you flip
the top panel up (see
page 22 for setting).
•If Any Key Answer is
set to On, you can also
press any number key
on the keypad to
answer a call (see page
22 for setting).
•While using the
handset speaker phone
or a headset, closing
the top panel will not
hang up the call.
•To scroll through the
help, press the >>|
soft key or right key.
note
UP742.book Page 35 Thursday, February 3, 2005 9:39 PM