GN Netcom ELT 560 - Manual (Page 15)

Changing the
Digital
Se
cu
r
i
t
y
C
o
de
C h a n g i n g t h e D i g i t a l S e c u r i t y C o d e [ 1 4 ] w w w . u n i d e n . c o m
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code:
1. Perform the "System Reset" options ("De-register the Handset" and "Replacing
the Base Setting") for all the handsets you have (see page 63).
2. Re-register each handset by following the steps on page 12.
Installing the Holster
- Line up the groove on the back of the handset with the groove
on the holster. The handset fits in the holster only one way.
- Slide the phone into the holster.
- Use the spring clip to attach the holster to your belt or
pocket.
You must remove the
holster to charge the
handset.
note
UP742.book Page 14 Thursday, February 3, 2005 9:39 PM