Gaggia Titanium - Manual (Page 34)

ENGLISH
•  •
9. Place a receptacle of adequate capacity beneath the steam pipe
and press the button (27).
RINSE MACHINE
OPEN KNOB
10 Turn the steam knob (16) anticlockwise to empty out the contents
of the water tank
MACHINE IS RINSING
11 When the machine rinse cycle is completed the display will
show:
RINSING FINISHED
CLOSE KNOB
12 Close the tap, reload the circuit and let the machine heat up
If you use a product other than the recommended one,
you should follow the manufacturer’s directions on the
package.
12.1 Interrupting the descaling cycle
If the descaling cycle is interrupted by switching the
machine OFF, it will automatically resume when the
machine is switched back ON.
The descaling cycle can be interrupted by turning the steam knob (16)
clockwise and then pressing the button (27).
The display will show:
DESCAL. INTERRUPTED
EMPTY WATERTANK
warning! After interrupting the cycle you must empty
the water tank of the descaling solution and wash out
the tank with fresh drinking water; the machine circuit must be
cleansed by carrying out a rinse cycle. The display will show:
RINSE MACHINE
PRESS KEY
Follow the directions for a normal rinse cycle provided in section
8 of the previous chapter.
13 fuNcTIoN PRogRAmmINg
The user can change some machine operating para-
meters according to personal needs.
13.1 mENu/oK command
In order to program functions you must access the programming mode by
pressing “MENU/OK” (28) when the machine is in a standby status.
To select the desired function, press the “∧” button to move up one
line or the “∨” button to move down on the display.
To exit the programming mode press “ESC”
13.2 choosing individual functions
Select the desired function by pressing “∧” or “∨”. Press
“MENU/OK” to enable the desired function; you can browse the
selectable settings using the “∧” or “∨” button; to store a setting
press “MENU/OK”.
Note: by pressing “ESC” you can exit the programming
mode at any time without saving the changes made;
exiting without saving is possible only before you have pressed
“MENU/OK”.
13.3 Description of programmable func-
tions
ENERGy SAVING
If the appliance is used little, it may be switched to the ENERGY SAVING
mode. This function allows electricity costs to be reduced. However, it is
recommended to switch the appliance off completely using the on/off
switch (7) if it is not to be used for a prolonged period. It will take the
machine just a few minutes to heat up when you switch it back on.
• In the programming mode press “∧” or “∨” to select the func-
tion:
ENERGY SAVING
and enable it by pressing “MENU/OK”; the following message will
appear:
ENERGY SAVING
in this mode the machine remains on but no components are
active.
• To deactivate the “ENERGy SAVING” function, press “MENU/
OK”.