Gaggia Titanium - Manual (Page 37)

ENGLISH
•  •
TOTAl COFFEES
This function allows you to display how many coffees the appliance
has made to date.
• After accessing the programming mode, press “∧” or “∨” to select
the function:
TOTAL COFFEES
enable it by pressing “MENU/OK”. The display will show, for
example:
TOTAL COFFEES
86
TIMER
This coffee maker features a new function that allows you to save energy
in case of long periods of quiescence. This function, which is factory set,
automatically switches the machine from the
SELECT PRODUCT
READY FOR USE
status to the
ENERGY SAVING
mode after 3 hours have elapsed since the previous use.
• The switch-off time can be set at 15-minute intervals, down to a
minimum of 15 minutes. The function may not be disabled.
• In the programming mode press “∧” or “∨” to select the
TIMER
function and activate it by pressing “MENU/OK”.
The display will show:
STANDBY
AFTER: 3:00
• Press “∧” or “∨”to select the desired setting and press
“MENU/OK” to store it.
Note: if ON/OFF times have been activated through
the “ClOCK” function, this function will be ignored.
ClOCK
This function may be activated and deactivated by the user. It is used
to:
- display the current time when the machine is in the “ENERGY
SAVING” or “FUNCTION SELECTION” mode;
- program the machine to switch on and off at a specific time.
In order for the programming function to work properly, you must set
the clock to the current time.
• Press “∧” or “∨” to select the function:
CLOCK
enable it by pressing “MENU/OK”.
• Press “∧” or “∨” to select the function:
CLOCK TIME
enable it by pressing “MENU/OK”.
• Press “∧” or “∨” to set the current hour and memorise it by pressing
“MENU/OK”;
CLOCK TIME
1:18
Then press “∧” or “∨” to set the minutes and memorise the setting
by pressing “MENU/OK”.
The clock is set and the machine will go back to the previous
menu.
Note: keeping the buttons pressed down will allow you
to go through the numbers quickly.
Note: the clock setting is also maintained when the
machine is off
Displaying the time
• press “∧” or “∨” to select the function
SHOW CLOCK TIME
and enable it by pressing “MENU/OK”.
• press “∧” or “∨” to activate or deactivate the function