MITSUBISHI ELECTRIC CP900E - Manual (Page 18)

18
BEFORE OPERATION
2 2 2 2 2
INSTALLATION OF PRINT PAPER
Do not remove the seal on the print paper yet.
When using thermal paper, remove the seal as shown on the previous page.
1 1 1 1 1
Insert the print paper roller with gear on the left.
Press the folder
1
as shown right, and set the print paper roller.
2 2 2 2 2
Set the other side of roller without gear.
3 3 3 3 3
Remove the seal, and insert the edge of the print paper right below
the roller cover with arrow marks towards the front panel.
Make sure to insert the paper straight.
4 4 4 4 4
Feed the print paper through the paper outlet with your hand.
5 5 5 5 5
Pull the both side of the print paper to eliminate slack.
2
1
1
Paper Paper Paper
Gear
Front side
Right side
Left side
arrow marks
Seal