MITSUBISHI ELECTRIC CP900E - Manual (Page 48)

48
Gray part is
cut when
MARGIN CUT
is ON.
ANALOG COLOR ADJ
INPUT
COLOR/B&W
BRT 0
CONT 0
R-SUB 0
G-SUB 0
B-SUB 0
COLOR 0
APT
0
CENTER
CANCEL
C
M
Y R
G
B
ADJUSTMENTS & SETTINGS (SERVICE MENU)
ANALOG COLOR ADJ Analog colour adjustment display
• This menu is used to adjust the image of analog input signal before storing in the memory.
INPUT Selects processing of video signal.
COLOR Processes as colour video signal.
B&W Processes as monochrome video signal. (The image is shown in
black and white.) Select B&W when inputting monochrome signal.
BRT(Bright) Adjusts the brightness of the printing image.
CONT(Contrast) Adjusts the contrast of the printing image.
R-SUB Adjusts red-subcontrast of the printing image. Red is added with
] and blue is added with [ .
G-SUB Adjusts green-subcontrast of the printing image. Green is added
with
]
and pink is added with
[
.
B-SUB Adjusts blue-subcontrast of the printing image. Blue is added with
] and yellow is added with [ .
COLOR Adjusts density of the printing image. The colour of the image gets
deeper with
]
and lighter with
[
.
APT(Aperture) Adjusts the contour of image. The contour is reinforced with ] and
softened with [ .
CENTER Initializes each setting. When pressing
]
, the values of BRT,
CONT, R-SUB, G-SUB, B-SUB,COLOR, and APT will be reset to the
centre value.
CANCEL Initializes each setting in ANALOG COLOR ADJ.
Hi/Mid/Low Adjusts the colour depth of image by selected point.
POINT(Hi/Mid/Low) Selects the point to adjust the colour depth.
(EXAMPLE) Pointing lighter colour much lighter;
Set the setting level for POINT(Hi) and Hi higher.
NOTE
It takes time to set the gamma value by CPU. Wait until the normal display is shown
after pressing SET button.
It may also take time to switch the program when the value of gamma setting is changed.
LAYOUT2 Layout setting display 2
PRN V AREA Adjusts the vertical position of memory image.
Setting area -10 ~ 10 (adjusts 2 lines each)
• This menu is displayed only when IMAGES is set for 2 in L size paper.
• PRN V AREA permits adjustment of the vertical position of the image so
that the clipped part of the image can be moved higher and lower.
SEPARATE Selects whether a white frame is added to each print or not.
OFF Prints without white frame. (A white frame appears according to
the settings of LAYOUT)
ON Prints with white frame.
MARGIN CUT Cuts the margin of the printed paper.
• This function is very convenient to stick the printed image on the card. The figure
shows S size print paper setting.
OFF Margin is not cut.
ON Margin is cut.
• Only OFF is displayed when selecting THERMAL : ON.
LAYOUT2
PRN V AREA (L2 ONLY) 0(-10~10)
SEPARATE OFF/ON
MARGIN CUT OFF/ON