MITSUBISHI ELECTRIC CP900E - Manual (Page 58)

58
CLEANING
Cleaning part
A small amount of alcohol
How to hold tissue paper
Cleaner pen (Option)
Ink sheet sensor
Front panel
Rubber roller
Cleaning as indicated below will help maintain stable printer operation and extend the
printer’s life.
Preparations
Alcohol (isopropyl alcohol)
Tissue paper (Fold in half about 4 times, and use the folded side to clean.)
Cotton buds
Cleaning kit (Option)*
Other : Cleaner pen (Option)*
*Please ask the dealer about options.
Make sure to turn off the power before cleaning.
1 1 1 1 1
Press OPEN button to pull the printing mechanism out.
2 2 2 2 2
Remove the ink cassette and print paper.
3 3 3 3 3
Wipe the ink sheet sensor.
Clean the parts circled in the right figure.
Wipe with tissue paper etc. which is soaked in a small amount of alcohol carefully.
4 4 4 4 4
Wipe the ink sheet sensor reflection plate.
Clean the metal reflection plate.
Wipe with tissue paper etc. which is soaked in a small amount of alcohol carefully.
5 5 5 5 5
Wipe the head.
Cleaning the part under the thermal head which develops heat.
Wipe the head cleaning part carefully with tissue paper etc. which is soaked in a
small amount of alcohol.
NOTE
• Do not damage the thermal head.
• When the symptom of the poor print quality is not corrected even if the head is
cleaned, replacing the thermal head is required. Contact your dealer.
• Thermal head is hot right after printing. Wait until the head temperature is low
when cleaning the thermal head.
6 6 6 6 6
Clean the rubber roller.
The seal paste and dust etc. are stuck on the rubber roller if you use it for a long time.
Wipe with tissue paper etc. which is soaked in a small amount of alcohol carefully.
Ink sheet sensor reflection plate
Thermal head
CLEANING