Multi-Tech Systems RAS96 - Manual (Page 41)

4 BIOS Setup Utility
CommPlete Communications Server 35
through 1 hour, except for HDD Power Down, which can be set from
1 minute through 15 minutes.
PM Control by APM
When this item is enabled, Advanced Power Management device will keep the system
time updated when the computer enters suspend mode activated by the BIOS power
management.
If Max Power Saving is not enabled, this will be preset to No.
Yes APM enabled.
No APM disabled.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC + Blank The system turns off the vertical and horizontal
synchronization ports and writes blanks to the video buffer.
Blank Screen The system only writes blanks to the video buffer. Use for
monitors that do not have a power management feature.
Doze Mode
When enabled, and after the set time of system inactivity, the CPU clock runs at a
slower speed while all other devices still operate at full speed. This mode can be
disabled or set from 1 minute through 1 hour. Configurable only when User Defined
Power Management has been selected.
Standby Mode
When enabled, and after the set time of system inactivity, the fixed disk drive and the
video are shut off while all other devices still operate at full speed. This mode can be
disabled or set from 1 minute through 1 hour. Configurable only when User Defined
Power Management has been selected.
Suspend Mode
When enabled, and after the set time of system inactivity, all devices except the CPU are
shut off. This mode can be disabled or set from 1 minute through 1 hour. Configurable
only when User Defined Power Management has been selected.
HDD Power Down
When enabled, and after the set time of system inactivity, the hard disk drive is
powered down while all other devices remain active. This mode can be disabled or set
from 1 minute through 15 minutes. Configurable only when User Defined Power
Management has been selected.