Multi-Tech Systems RAS96 - Manual (Page 76)

RAS96 RASCard User Guide
CommPlete Communications Server 68
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
The hard disk cannot be initialized. Make sure the adapter is installed correctly and all
cables are correctly and firmly attached. Also, make sure the correct hard disk type is
selected in Setup.
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize controller. Make sure that the correct hard disk type is selected in
Setup. Also check to see if a jumper needs to be set correctly on the hard disk.
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT
Cannot find or initialize the floppy drive controller. If there are no floppy drives
installed, be sure the Diskette Drive selection in Setup is set to NONE.
KEYBOARD ERROR OR NO KEYBOARD PRESENT
Cannot initialize the keyboard. Make sure the keyboard is attached correctly, and no
keys are being pressed during the boot.
If you are purposely configuring the system without a keyboard, set the error halt
condition in Setup to HALT ON ALL, BUT KEYBOARD. This will cause the BIOS to
ignore the missing keyboard and continue the boot.
Memory Address Error at ...
Indicates a memory address error at a specific location. You can use this location along
with the memory map for your system to find and replace the bad memory chips.
Memory parity Error at ...
Indicates a memory parity error at a specific location. You can use this location along
with the memory map for your system to find and replace the bad memory chips.
MEMORY SIZE HAS CHANGED SINCE LAST BOOT
Memory has been added or removed since the last boot. Enter Setup and enter the new
memory size in the memory fields.
Memory Verify Error at ...
Indicates an error verifying a value already written to memory. Use the location along
with your system’s memory map to locate the bad chip.
OFFENDING ADDRESS NOT FOUND
This message is used in conjunction with the I/O CHANNEL CHECK and RAM
PARITY ERROR messages when the segment that has caused the problem cannot be
isolated.