Martin Fireplaces 400BWBIA - Manual (Page 13)

61D0008 13
��
�
�
�
�
���
���������
��������������
���
������
��������������
�� � �
�
���������������������
�� � �
�
���������������������
��
�
�
�
�
���
21 3 /
4
"min
13"min
FIREPLACE INSTALLATION
UNPACKING FIREPLACE
Unpack and check the fireplace and chimney for damage. If any items are been damaged or missing, contact your Martin Hearth
and Heating dealer. Do not substitute parts. Use only parts listed for use with Martin Hearth and Heating Models 400BWBA,
400BWBIA, 400BWBCA, 400BWBCIA. 500BWBA, 500BWBIA, 500BWBCA and 500BWBCIA fireplaces.
CLEARANCES
1. Provide required clearances shown in Figures 10 through 12. Provide 2" minimum chimney air space clearance to com-
bustibles.
2. Place fireplace in the desired location. Securely support and level fireplace. Check face of the fireplace with a carpenterʼs
level. If fireplace is not plumb, correct it by placing shims under the edges of fireplace.
3. Block in the fireplace to prevent any shifting of firebox. Secure fireplace with nails or screws through the flanges located on
each side of the fireplace. Do not enclose the fireplace until the combustion air duct and chimney pipes are installed.
Note: Some local codes may require electrically grounding the fireplace and chimney.
Continued
Figure 10 - Minimum Clearances for Corner
Installation
Figure 11 - Minimum Clearances for Wall Installation