Read register value command, Result code format command, Result code options command – Multi-Tech Systems MT5634MSV User Manual
Page 42: Result code selection command, Result codes enable/disable command, Reading, Setting, Set register value command, Tone dialing command, Messagesaver user guide
MessageSaver User Guide
34
Command:
Q
n
Result Codes Enable/Disable
Values:
n = 0 or 1
Default:
0
Description:
Q0
Enables result codes.
Q1
Disables result codes.
Q2
Returns an OK for backward compatibility with some soft-
ware.
Command:
S
r=n Set Register Value
Values:
r = S-register number; n varies
Default:
None
Description:
Set value of register Sr to value of n, where n is entered in deci-
mal format. E.g., S0=1.
Command:
S
r?
Read Register Value
Values:
r = S-register number
Default:
None
Description:
Read value of register Sr and display it in 3-digit decimal form.
E.g., S2? gives the response 043.
Command:
T
Tone Dialing
Values:
P, T
Default:
T
Description:
Configures the modem for DTMF (touch-tone) dialing. Dialed
digits are tone dialed until a P command or dial modifier is
received.
Command:
V
n
Result Code Format
Values:
n = 0 or 1
Default:
1
Description:
V0
Displays result codes as digits (terse response).
V1
Displays result codes as words (verbose response).
Command:
W
n
Result Code Options
Values:
n = 0, 1, or 2
Default:
2
Description:
W0
CONNECT result code reports serial port speed, disables pro-
tocol result codes.
W1
CONNECT result code reports serial port speed, enables pro-
tocol result codes.
W2
CONNECT result code reports line speed, enables protocol re-
sult codes.
Command:
X
n
Result Code Selection
Values:
n = 0–7
Default:
4
Description:
X0
Basic result codes (e.g., CONNECT); does not look for dial tone
or busy signal.
X1
Extended result codes (e.g., CONNECT 46000 V42bis); does not
look for dial tone or busy signal.
X2
Extended result codes with NO DIALTONE; does not look for
busy signal.