3 operational restrictions, 1 radar avoidance, Operational restrictions – Motorola PTP 400 Series User Manual

Page 41: Radar avoidance

Advertising
background image

39

When shipped from the factory, units are configured as follows:

• 4.9 GHz PTP 400 Series Bridge – Region Code 14
• 5.4 GHz PTP 400 Series Bridge – Region Code 9
• 5.8 GHz PTP 400 Series Bridge – Region Code 1

WARNING

To meet the regulatory requirements of your region you should set the correct

Region Code by obtaining a new License Key from you reseller or distributor.

5.3 Operational

Restrictions

5.3.1 Radar

Avoidance

Radar Avoidance requires that equipment used in the region:

• Detects interference from other systems and avoids co-channel operation with these

systems, notably radar systems.

• Provide on aggregate a uniform loading of the spectrum across all devices.

To address the primary aims the Spectrum Management algorithm implements a radar

detection function which looks for impulsive interference on the active channel only. If

impulsive interference is detected Spectrum Management will mark the current active channel

as having detected radar and initiate a channel hop to an available channel. The previous

active channel will remain in the radar detected state for thirty minutes after the last impulsive

interference pulse was detected. After the thirty minutes have expired the channel will be

returned to the available channel pool.

The radar detection algorithm will always scan the active channel for 60 seconds for radar

interference before using the channel. This compulsory channel scan will mean that there is a

60-seconds service outage every time radar is detected and that the installation time is

extended by 60 seconds even if there is found to be no radar on the channel.

NOTE:

On system installation or start-up this extends the initial scan time of the Master unit

by 60 seconds.

To address the “provide aggregate uniform loading of the spectrum across all devices”

requirement, the channel selection algorithm will choose a channel at random from a list of

available channels. The channel selection algorithm is initiated at link initialization and when

radar interference is detected.

Advertising