Motorola PTP 400 Series User Manual
Page 75
73
• Running at maximum receive mode:
The wireless link is operating at its receive maximum capacity. To confirm that the
wireless link is operating at its maximum transmit capacity either look at the 'Transmit
Modulation Mode' on this page or look at the peer wireless units 'Receive Modulation
Mode Detail' attribute.
• Running at user-configured Target Modulation Mode:
This indicates that the wireless link could operate at a higher capacity but has been
limited in modulation mode by the user from the configuration page.
• Restricted because Installation is armed:
During installation the wireless link is restricted to operate in a low order modulation
mode (BPSK ½ ). Disarming the wireless units after installation will allow the wireless link
to adaptively select its own operational modulation mode.
• Restricted because of byte errors on the wireless link:
During normal operation the wireless link monitors its performance. If byte errors are
detected during normal data transmission / reception the wireless unit automatically
changes the active modulation mode to a more robust mode in order to reduce the
number of errors.
• Restricted because a DFS channel change is in progress:
During Spectrum Management (DFS) channel changes the wireless unit temporarily
reduces the modulation mode to BPSK ½.
• Restricted due to the low Ehthernet link speed:
If the Ethernet link speed is less that the instantaneous wireless link capacity then the
modulation mode is optimized so that the Ethernet link speed is satisfied using the most
robust modulation mode.
• Limited by the wireless conditions:
The wireless link capacity is limited by the current wireless conditions e.g. interference,
excess path loss, etc…
Range:
The range
between the peer PTP 400 Series Bridge units.
Refresh Page Period:
-
The Status page refreshes automatically according ti the setting
entered here (in seconds).
17
The 400 Series Bridge displays range in km by default, if the user would prefer to display range
using Miles the ‘Distance Units’ attribute should be set to imperial, see the “
” web page
section 8.3.19
Properties
18
This option is only available to the System Administrator