Motorola PTP 400 Series - Manual (Page 96)

94
8.3.5.1 Manually Configuring the Wireless Units
If the installer / system administrator wishes, they may modify the default installation
configuration. If only the IP addresses are incorrect it is recommended that the values are
changed via the configuration menu (Section 8.3.1). If any other parameters require
modification then it is recommended that the system administrator use the Installation Wizard.
The operational software for the PTP 400 Series Bridge requires a license key to enable the
wireless bridging capability and program region code specific parameters in to the unit.
Please refer to Section 8.3.18 for more information on how to enter and validate a license key
into the unit.
8.3.5.2 Internet Protocol Configuration
Step 1 of the installation wizard requires the installer to enter the Internet Protocol (IP)
configuration.
Figure 41 - Installation Wizard Internet Protocol Configuration.