Marantz DLP PROJECTOR VP-12S2 - Manual (Page 22)

18
ENGLISH
1. Press the STANDBY key on the remote controller or the POWER key on the projector.
2. The fan continues to run for a while to reduce internal heat. The POWER ON indicator flashes in blue and no key will be
active. After about one minute of cooling has been done, the unit turns off and the STANDBY indicator lights up.
Notice : Do not pull out the AC power cord until the projector turns in standby mode.
Notice :
- Do not pull out the power cord suddenly in the state of “POWER ON." It can cause a breakdown.
- When a WARNING indicator lit up or blinks in red, pull out the AC power cord after checking that the fan has stopped.
- The projector will not be turned on if the
POWER ON key on the remote controller or the POWER key on the projector is
pressed immediately after turning off. Press the POWER ON key on the remote controller or POWER key on the projector
after the projector turns into standby mode.
To Turn off the Power