Marantz DLP PROJECTOR VP-12S2 - Manual (Page 9)

5
ENGLISH
Rear and Terminals View
13
14
Lamp cover
securing screw
Lamp cover
IR sensor
1 2 3 4 5
7 8 9 10 11
Terminals
6
!4 AC IN ( ☞
P.8)
Connect the supplied AC power code.
❖
Terminals
z RGB IN
Connect the analog RGB output from an IBM VGA or compatible
equipment.
x COMPONENT VIDEO IN
Y, P B /C B , P R /C R connectors.
Connect the COMPONENT VIDEO output from video
equipment or an A/V processor/receiver with a component
video output.
c S-VIDEO IN
Connect the S-VIDEO output from a video equipment.
v VIDEO IN
Connect the composite video output from a video equipment.
b TRIG.1(TRIGGER 1)
When the unit is turned on, 12V is output. When the unit is
turned off, no voltage is output. This allows such as a powered
up/down screen,whenever the projector is turned on or off.
Note:
To connect with external devices, use an ordinal 35mm mini-
plug (mono) cable with attaching the supplied ferrite core.
n TRIG.2(TRIGGER 2)
Select ON or OFF at each aspect mode, such as Full, Normal,
Zoom, and Through to control screen aspect ratio with powered
up/down dual aspect ratio screen.
Notes:
• Do not use TRIG.1 and TRIG.2, as the power source.
• To connect with external devices, use an ordinal 35mm mini-
plug (mono) cable with attaching the supplied ferrite core.
m RS-232C
Connect the RS-232C of equipment for external control.
, REMOTE CONTROL IN/OUT
By connecting this projector to another Marantz audio component
using a supplied System Control cable, you can remotely operate
the components as a single system.
• When connecting to component with a remote sensor (such
as the SR9200,SR8200), be sure to connect the "REMOTE
CONTROL IN" jack of this projector to the "REMOTE
CONTROL OUT" jack of the component with the remote
sensor.
• When connecting to component which is not equipped with
a remote sensor, be sure to connect the component to the
"REMOTE CONTROL OUT" jack of this projector.
. REMOTE switch (EXT. / INT.)
When using this projector independently, set this switch to
"INT.". When using this projector in a system with a Marantz
DVD player or AV Receiver equipped with a remote sensor,
set the switch to "EXT.".
⁄0 LIGHT ON/OFF
Select ON : The terminal panel lights up.
⁄1 DVI-D IN
Connect the digital RGB signal (TMDS compliant, single link
only)
Note: To use the DVI-D terminal, please follow the cautions
on page 9.
!5 Adjustment lever ( ☞
P.11)
Lift the projector and turn the adjustment lever right or left.
The adjustable feet will extend from the projector. Then,
release the lever, the adjustable feet is locked.
!6 Screw holes for ceiling mount kit
15
13
13
Adjustable
feet
16
15
16
Adjustable feet
Bottom View