Marantz DLP PROJECTOR VP-12S2 - Manual (Page 29)

25
ENGLISH
The following adjustments can be made:
– OSD Position (16:9 / 4:3)
Select OSD position from 16:9 or 4:3.
– Reset Lamp Life
Lamp Life must be reset immediately if the lamp is replaced. Select “Reset Lamp Life” from Config menu. The menu shown
below is displayed.
Again, select “Yes”, and press the ENTER key. Then the lamp life is initialized.
– Reset All
All settings are reset to the factory default settings except the lamp life.
When the user selects “Yes”, the following message appears:
Again, select “Yes”, and press the ENTER key.
Yes No
Reset All ?
Yes No
Reset Lamp Life ?
4 : 3 OSD position 16 : 9 OSD position
Picture Adjust
Setting
Display
Config
Trigger 2
Memory
Contrast
Brightness
Color
Sharpness
Tint
Noise Reduction
Color Temp.
Fine Menu
50
44
64
6
0
0
Middle
Picture Adjust
Setting
Display
Config
Trigger 2
Memory
Contrast
Brightness
Color
Sharpness
Tint
Noise Reduction
Color Temp.
Fine Menu
50
44
64
6
0
0
Middle
Picture Adjust
Setting
Display
Config
Trigger 2
Memory
Lamp Mode
High Bright
OSD Position
Language
Ceiling
Rear
Reset Lamp Life
Reset All
High
Off
16:9
English
Off
Off
Configuration
Lamp mode High, Low
High Bright On, Off
High Bright On : Display brightest image.
OSD Position 16:9, 4:3
Language
English, German, French, Spanish,
Portuguese, Italian
Ceiling On, Off
On: The picture is reversed horizontally
and vertically.
Rear On, Off
On: The picture is reversed horizontally.
Reset Lamp Life Yes, No
Reset All
Yes, No