Monarch Instrument 9402 - Manual (Page 23)

4. Press
8
twice to exit to the Main menu and save your
changes.
NOTE: The printer will not save your changes if you turn
it Off before returning to the Main menu.
Print Position
This function adjusts the vertical print position on the supply.
You can adjust the print if it is too close to the top or bottom of
the supply, or overtypes the pre-printed area ("MONARCH" in
the sample below). The adjustments are in dots (0.0052 inch),
which is the smallest measurement the printer recognizes.
The range is from -999 to +999 (5.20 inches), and the default
is 0.
NOTE: When you adjust the print position, you need to check
and possibly adjust the supply position.
•
If the data is too close to the bottom, increase the
number.
•
If the data is too close to the top, decrease the number.
NOTE: Make sure Re-Image All is set to Yes when you
change this setting. See the section in Chapter 6,
"Re-Image All."
S
e
tt
ing
S
upp
ly
Opt
io
n
s
3. Setting Supply Options
3-5