Multi-Tech Systems MVP120 - Manual (Page 18)

18
Chapter 2 - Installation
Multi-Tech Systems, Inc. MultiVOIP User Guide
Cabling Your MVP120
Cabling your MVP120 involves making the proper Power, Command Port, and Network
connections. The graphic below shows the back panel connectors and the associated cable
connections. The Cabling Procedure section provides step-by-step instructions for cabling
your MVP120.
POWER ETHERNET COMMAND PHONE
Cable Connections
Cabling Procedure
1. Using the supplied cable, connect the power supply to a live AC outlet, then plug the
power supply into the MVP120 as shown above.
2. Connect the MVP120 to a PC using the RJ-45 to DB9 (female) cable provided with
your unit. Plug the RJ-45 end of the cable into the Command port of the MVP120
and connect the other end to the PC’s serial port.
3. Connect a network cable to the Ethernet 10Base-T connector on the back of the
MVP120. Connect the other end of the cable to your network.
4. If you are connecting a PSTN or FXO/PBX port to your MVP120, connect one end of
an RJ-11 cable to the Phone connector on the back of the MVP120 and the other
end to the PSTN or FXO port on the PBX.
5. Turn on power to the MVP120 by setting the power switch on the right-side panel to
the On position. Wait for the Boot LED on the MVP120 to go off before proceeding.
This may take a couple of minutes.
Note: Since the MVP120 doesn’t have a power LED, no LEDs will be on after
booting unless the Ethernet link is active.