Multi-Tech Systems MVP120 - Manual (Page 70)

70
Chapter 8 - Remote Configuration and Management
Multi-Tech Systems, Inc. MultiVOIP User Guide
LAN-Based
The LAN-based remote configuration requires a Windows Sockets compliant TCP/IP stack. TCP/IP
protocol software must be installed and functional before the configuration program can be used.
1. You must assign an Internet (IP) address for the PC and for each node that will be managed
by the configuration program. Refer to the protocol software documentation for instructions
on how to set the IP addresses. It is recommended that you ping each MultiVOIP to verify
the connection and its IP address.
Once you have completed this step, you should be able to use the protocol Ping command
for the PC host name. You should also test the network interface configuration by Pinging
another TCP/IP device that is connected to the network.
2. Install the MVP120 software on the local PC. When installed, click Start | Programs |
MultiVOIP 100 | Configuration Port Setup, or double-click the Configuration Port Setup
icon in the MultiVOIP 100 program group.
3. The MultiVOIP Port Setup dialog box displays.
Verify that IP is set for the Communication Type.
In the MultiVOIP IP Address box, enter the IP Address of the remote MultiVOIP.
4. Click OK when you are satisfied with your selections.
5. Run the MultiVOIP Configuration program. Click Start | Programs | MultiVOIP 100 |
MultiVOIP Configuration, or double-click the MultiVOIP Configuration icon in the
MultiVOIP 100 program group.
6. The MultiVOIP 100 Setup dialog box displays. This is the dialog box of the remote
MultiVOIP. Refer to the online Help provided with your MultiVOIP for the definition of each
dialog box and field within a dialog box.