Multi-Tech Systems MVP120 - Manual (Page 24)

Multi-Tech Systems, Inc. MultiVOIP User Guide
Chapter 4 - Configuring the Master MultiVOIP
24
Chapter 4 - Configuring the Master MultiVOIP
The following steps provide instructions for configuring your MVP120. The configuration
sequence includes IP Protocol default setup, Channel setup, and Phone Directory Database
setup. The numbering of steps continues from the previous section.
12. The IP Protocol Default Setup dialog box displays.
The default Frame Type is TYPE_II. If this does not match your IP network, select SNAP
from the Frame Type list. The available Frame Type choices are TYPE_II and SNAP.
13. In the Ethernet group, enter the IP Address, Subnet Mask, and Gateway Address
unique to your IP LAN.
The IP address is the unique LAN IP address that is assigned to the MVP120, and the
Gateway address is the IP address of the device connecting your MVP120 to the
Internet.
Click OK when you are finished.
14. The Channel Setup dialog box displays. The four tabs in this dialog box define the
Channel Interface, Voice/Fax parameters, Billing/Miscellaneous parameters, and
Regional telephone parameters.
Check with your in-house telephone personnel to verify whether your local PBX dial
signaling is Pulse or DTMF (tone). Select the regeneration option accordingly.
In the Inter Digit Time box, enter the maximum amount of time between dialed digits in
milliseconds that the unit will wait before mapping the dialed digits to an entry in the
Phone Directory Database. If too much time elapses between digits, the wrong numbers
will be mapped and you will hear a rapid busy signal. If this happens, hang up and dial
again. The default setting is 2 seconds.
In the Flash Hook Timer box, enter the amount of time the duration of flash hook signals
output on the interface. The default setting is 600 milliseconds.