At command set (continued) – Motorola 3460 User Manual
Page 117
3460 Fast’R
B-7
1
=Enable. Data compression is attempted.
If the modem is using LAPM error correction, it uses
V.42bis data compression when DC=Enabled. Note: In
an application with SDC enabled, LAPM error
correction and V.42bis data compression only are used.
With MNP error correction, the modem attempts to
negotiate V.42bis and MNP-5 data compression with the
remote modem.
Depending on which data compression type the remote
modem can accommodate, V.42bis or MNP-5 is used.
Otherwise, no data compression is used.
*
DD
Dial Wait Period (Pause After Dialing)
0
The modem waits 2 seconds for a dial tone.
1
The modem waits 3 seconds for a dial tone.
2
The modem waits 4 seconds for a dial tone.
3
The modem waits 6 seconds for a dial tone.
4
The modem waits 12 seconds for a dial tone.
5
The modem waits 15 seconds for a dial tone.
6
The modem waits 20 seconds for a dial tone.
7
The modem waits 30 seconds for a dial tone.
8
The modem waits 40 seconds for a dial tone.
9
Dial wait is determined by setting S-Register 7.
*
DE
DTE (Computer) Port Rate
0
=75 BPS
1
=150 BPS
2
=300 BPS
3
=600 BPS
4
=1.2 KBPS
5
=2.4 KBPS
6
=4.8 KBPS
7
=7.2 KBPS
AT Command Set
(continued)
Command
Option
Description
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.