Motorola 3460 - Manual (Page 137)

3460 Fast’R
B-27
&T Test
0 =End Test
1 =Initiate Local Analog Loopback (LAL)
3 =Initiate Local Digital Loopback (LDL). Note: this test
is not supported in Reliable mode (AT*SM2)
4 =Accept Remote Digital Loopback (RDL)=On
5 =Accept Remote Digital Loopback (RDL)=Off
6 =Initiate Remote Digital Loopback (RDL)
7 =Initiate Remote Digital Loopback (RDL) Pattern
8 =Initiate Local Analog Loopback (LAL) Pattern
&V Status Message
0 =Long Form
1 =Short Form
&W Save Changes
Saves changes to a option sets made with AT commands.
(If you do not save the changes made with AT
commands, the modem does not store them in nonvola-
tile memory.) After selecting an option set (ATZn; n=0,
1, or 2), and changing options, enter AT&Wn. The
modem displays Saving Options, then Save Completed!.
0 or 1 =Save changes to Option Set 1
2 =Save changes to Option Set 2
&X Clock Signal Source
Sets modem timing. Applies to synchronous
applications. For most dial applications, use option 0.
0 =Internal. The modem uses timing signals passed on
EIA/TIA 232-D Pin 15 (V.24 circuit 114).
1 =External. The modem uses external timing signals
passed on EIA/TIA 232-D Pin 24 (V.24 circuit 113).
2 =Loopback. The modem uses loopback timing signals
passed on EIA/TIA 232-D Pin 17 (V.24 circuit 115).
AT Command Set (continued)
Command Option Description
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.