Motorola 3460 - Manual (Page 63)

3460 Fast’R
3-11
ATX4=Modem waits for dial
tone and detects busy signal.
Uses only NO CARRIER,
CONNECT, CONNECT
<Rate>, BUSY, and NO DIAL
TONE result codes.
Terminal Options
Terminal Inactivity
Disconnect Country-specific S30=n; n=0-255 sec.
DCD Loss Disconnect Country-specific S10=n; n=1-255 sec.
Telco or Telco Jack Options
DL TX Level (dB) Country-specific AT * DX0 - AT * DX30
LL Tx Level (dB) Country-specific AT * LX0 - AT * LX30
Speaker Control ATM1=Dialing ATM0=Always Off
ATM2=Always On
ATM3=On During
Training
Speaker Volume ATL2=Medium ATL0 or ATL1=Soft
ATL3=Loud
Dial Line Filter AT * LF2=Short AT * LF0=Long
AT * LF1=Medium
AT * LF2=Short
AT * LF3=Not
recommended
Dialing Options
Pause Delay Country-specific ATS8=n; n=value
Dial Wait Country-specific AT * DD0 - AT * DD9
Dial Mode Country-specific AT * PT0 - AT * PT2
Call Timeout Country-specific AT * TT0 - AT * TT5
Blind Dial Country-specific ATS6
Pulse Cycle Country-specific AT&P0 - AT&P2
Tone Length Country-specific ATS11
Auto Redial Country-specific AT * DR0 - AT * DR15
Table 3-5. Site-Specific Parameters (continued)
Parameter Default Option Available Option