Miller Electric MILLERMATIC 350P - Manual (Page 16)

.
A complete Parts List is available at www.MillerWelds.com
OM-1327 Page 12
3-3. Volt-Ampere Curve
217 443-A
1 Normal Volt-Ampere Curves
The volt-ampere curves show the
normal minimum and maximum
voltage and amperage output
capabilities of the welding power
source. Curves of other settings fall
between the curves shown.
MAXVOLTS
MINVOLTS
0 50 100 150 200 250 300 350
0
10
20
30
40
50
60
70
80
90
VOL
TAGE
AMPERAGE
3-4. Connecting To Weld Output Terminals
803 778-A
! Turn off power before connecting to
weld output terminals.
! Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your ma-
chine.
1 Weld Output Terminal
2 Supplied Weld Output Terminal Nut
3 Weld Cable Terminal
4 Copper Bar
Remove supplied nut from weld output ter-
minal. Slide weld cable terminal onto weld
output terminal and secure with nut so that
weld cable terminal is tight against copper
bar. Do not place anything between weld
cable terminal and copper bar. Make
sure that the surfaces of the weld cable
terminal and copper bar are clean.
Tools Needed:
3/4 in. (19 mm)
4
2
3
Do not place
anything between
Correct Installation Incorrect Installation
1
weld cable terminal
and copper bar.