Miller Electric MILLERMATIC 350P - Manual (Page 28)

.
A complete Parts List is available at www.MillerWelds.com
OM-1327 Page 24
3-19. Threading Welding Wire For XR Edge, XR-A Gun, XR-A Python, Or XR - Aluma-Pro
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Drive Roll
5 Intermediate Wire Guide
6 Outlet Wire Guide
7 Pressure Adjustment Knob
8 Gun Conduit Cable
Lay gun cable out straight.
Tools Needed:
6 in.
(150 mm)
.
Hold wire tightly to keep
it from unraveling.
Open pressure assembly.
Pull and hold wire; cut off end.
Push wire thru guides into gun;
continue to hold wire.
Close and tighten pressure
assembly, and let go of wire.
See Section 3-20 for threading
welding wire through XR guns.
Ref. 803 544-B / 218 243-A / 218 244-A / S-0627-A
Tighten
1
2
3
4
.
Use pressure indicator scale to
set front drive roll pressure to 1
and rear drive roll pressure to
less than 1.
Pressure
Indicator
Scale
218243-A
IMPORTANT!
For Aluminum Push-Pull welding.
Thread hub tension nut loosely
IMPORTANT!
For Aluminum
Push-Pull welding.
1 2 3 4
218244-A
7
8
3 5 6 2 1 4