Maytag AOES3030 - Manual (Page 30)

B—2 16021875 Rev. 0 ©2003 Maytag Appliances Company
+
-
P
R
E 3 5 0 °
TIME CONTROL OVEN CONTROL
LIGHT
OVEN
CANCEL
TIMER
ON / OFF
CLOCK
STOP
TIME
COOK
TIME
BAKE BROIL CLEAN :
HR
DELAY BAKE CLN STOP TIME
BROIL
DELAY BAKE
CLEAN LOCKED O
N
Electronic Oven Control Options
LIGHT— Use to turn light on and off inside oven. Light
will automatically turn on when oven door is opened.
TIMER ON/OFF— Use to time any kitchen function or
cancel timer.
STOP TIME— Use to set delayed bake and delayed self
clean.
CLOCK — Use to set time of day.
OVEN CANCEL— Cancels any cooking or cleaning
function.
COOK TIME — Use to set timed or delayed baking.
BAKE— Use to set bake.
BROIL— Use to set broil
CLEAN— Use to set self-clean.
+ or - — Use to select temperature or time.
Special Oven Control Functions
Preheat Signal
After setting the oven to cook and selecting a
temperature, oven will preheat. When oven reaches set
temperature, a 1-second signal will sound.
End-of-Cycle Signal
When a timed cycle is complete, three long signals will
sound. End of cycle signal will continue to sound until
CANCEL is touched. If TIMER ON/OFF end-of-cycle
signal is sounding, touch TIMER ON/OFF.
Child Lockout
This is a safety feature used to prevent children from
accidentally programing oven. It disables electronic oven
control. Touch and hold BAKE and COOK TIME for 5
seconds. “OFF” will display where the temperature
normally appears. To reactivate control, press and hold
BAKE and COOK TIME pads for 5 seconds. Child
lockout feature must be reset after a power failure.
12-hour Automatic Cancel
This is a safety feature that prevents oven from continuing
to operate if it has been left on for over 12 hours. If a
cooking function continues longer than 12 hours without
any oven control options being touched, this feature turns
oven off. Any time an option is touched 12-hour
automatic cancel is reset.
Timer Signal
When time elapses, timer beeps 3 times then once every
10 seconds until cancelled.
Increasing
+
or -
Pad Speed
When setting time and temperature, hold pad to
accelerate rate at which numbers increase or decrease.
Self-diagnostic System
Electronic range control has a self-diagnostic system.
Self-diagnostic system sounds a series of short, rapid
beeps and shows an "F-code" in display when there is a
problem.
Programming Instructions—ERC for AOES3030