Maytag AOES3030 - Manual (Page 40)

C—2 16021875 Rev. 0 ©2003 Maytag Appliances Company
TIME CONTROL
LIGHT
OVEN
CANCEL
+
-
TIMER
ON / OFF
CLOCK
STOP
TIME
COOK
TIME
:
AM
PM
HR °
P
R
E 3 5 0
CONV BROIL PRE-
DELAY TIMED BAKE
CLEAN LOCK ON CLEAN OVEN STOP ON TIMER
BAKE BROIL
CONV
BAKE
CONV
CONV
BROIL
CLEAN
MULTI-MODE OVEN
THERMAL CONVECTION
Electronic Oven Control Options
LIGHT — Use to turn light on or off inside oven. Light will
automatically turn on when oven door is opened.
TIMER ON/OFF — Use to time any kitchen function or
cancel timer.
STOP TIME — Use to set delayed bake and delayed self
clean.
CLOCK — Use to set time of day.
OVEN CANCEL — Cancel any cooking or cleaning
function.
COOK TIME — Use to set timed or delayed cooking.
BAKE — Use to set bake.
BROIL — Use to set broil.
CONV BAKE — Use to set convection bake.
CONV — Use to set convection.
CONV BROIL — Use to set convection broil.
CLEAN — Use to set self-clean.
+ or - — Use to select temperature or time.
Special Oven Control Functions
Preheat Signal
After setting oven to cook and selecting a temperature,
oven will preheat. When the oven reaches the set
temperature, a 1-second signal will sound.
End-of-Cycle Signal
When a timed cycle is complete, three long signals will
sound. End of cycle signal will continue to sound until
CANCEL is touched. If TIMER ON/OFF end-of-cycle
signal is sounding, touch TIMER ON/OFF.
Child Lockout
This is a safety feature used to prevent children from
accidentally programing oven. It disables electronic oven
control. Touch and hold BAKE and COOK TIME for 5
seconds. “OFF” will display where the temperature
normally appears. To reactivate control, touch and hold
BAKE and COOK TIME for 5 seconds. Child lockout
feature must be reset after a power failure.
12 Hour Automatic Cancel
This is a safety feature that prevents oven from continuing
to operate if it has been left on for over 12-hours. If a
cooking function continues longer that 12-hours without
any options on oven control being touched, this feature
turns oven off. Any time an option is touched, 12-hour
automatic cancel is reset.
Timer Signal
When time elapses, timer beeps 3 times then once every
10 seconds until cancelled.
Increasing
+ or - Pad Speed
When setting time and temperature, hold pad to
accelerate rate at which numbers increase or decrease.
Self-diagnostic System
Electronic range control has a self-diagnostic system.
Self-diagnostic system sounds a series of short, rapid
beeps and shows a "F-code" in display when there is a
problem.
Programming Instructions—ERC for AOCS3040