Multitech V.90/K56FLEX MT5600ZDXV - Manual (Page 17)

17
User Guide
5. Turn on power by flipping the "ON/OFF" switch (on the side of the
modem) to the "ON" position.
6. Make sure modem and computer/terminal serial port baud rates are
adjusted. (Note that several programs can check this for you. If you have
MS-DOS 5.0 or higher, a program called MSD.EXE [Microsoft Diagnostics]
is in your DOS directory. Typing MSD at the DOS prompt brings up a screen
that provides a variety of information about your computer. Select COM
ports and it lists information about your com port, e.g., UART Type, Address,
and IRQ, to name a few. Once you know your serial port's UART type, you
can set your communications software appropriately.)
7. Proceed to Chapter 3 of this manual, or to your data communications
software manual.